[1]刘博研,薛伟辰,孙 哲.界面构造对预制混凝土柱接缝抗剪性能的影响研究[J].西安建筑科技大学学报(自然科学版),2022,54(02):164-173.[doi:10.15986/j.1006-7930.2022.02.002]
 LIU Boyan,XUE Weichen,SUN Zhe.Influence of interface structures on shear performance of precast concrete column joints[J].J. Xi’an Univ. of Arch. & Tech.(Natural Science Edition),2022,54(02):164-173.[doi:10.15986/j.1006-7930.2022.02.002]
点击复制

界面构造对预制混凝土柱接缝抗剪性能的影响研究()
分享到:

西安建筑科技大学学报(自然科学版)[ISSN:1006-7930/CN:61-1295/TU]

卷:
54
期数:
2022年02期
页码:
164-173
栏目:
出版日期:
2022-04-28

文章信息/Info

Title:
Influence of interface structures on shear performance of precast concrete column joints
文章编号:
1006-7930(2022)02-0164-10
作者:
刘博研薛伟辰孙 哲
(同济大学 土木工程学院, 上海 200092)
Author(s):
LIU Boyan XUE Weichen SUN Zhe
(College of Civil Engineering, Tongji University, Shanghai 20092, China)
关键词:
预制混凝土柱 接缝 界面构造 抗剪性能 计算方法
Keywords:
precast concrete column joint interface structure shear performance calculation method
分类号:
TU398+.9
DOI:
10.15986/j.1006-7930.2022.02.002
文献标志码:
A
摘要:
开展了4个轴压比为0.4的预制混凝土柱接缝的抗剪试验,研究了界面构造(凿毛注浆、齿槽注浆、光面注浆、凿毛叠合)对接缝抗剪性能的影响.凿毛注浆和凿毛叠合界面的凹凸深度约6 mm; 齿槽注浆界面的齿槽深度约20 mm; 光面注浆界面的凹凸深度小于2 mm.试验结果表明:接缝试件均发生剪切破坏; 试件的荷载-滑移曲线可分为弹性、滑移、极限和破坏四个阶段; 叠合接缝的抗剪刚度为注浆接缝的6.02~6.76倍; 各注浆接缝的抗剪刚度接近,相差不超过10.9%; 叠合接缝的抗剪承载力为注浆接缝的1.38~1.85倍; 齿槽注浆、凿毛注浆接缝的抗剪承载力分别比光面注浆接缝高33.5%和14.9%; 提高界面粗糙度或设置齿槽可增强接缝的抗剪性能.基于试验结果和以往文献中的试验数据,分析了现有接缝抗剪承载力计算方法的适用性.发现现行规范中计算方法对凿毛叠合和齿槽注浆接缝的计算结果大多过于保守,对凿毛注浆和光面注浆接缝的部分计算结果偏于不安全.根据试验数据和对比结果,提出了考虑界面构造影响的预制混凝土柱接缝抗剪承载力计算方法.
Abstract:
Shear tests were conducted on four precast concrete column joint specimens under the axial compression ratio of 0.4 in order to investigate the influence of interface structures on their shear performance. Four specimens had different types of joints, including the grouting joint with rough interface, the grouting joint with shear keys, the grouting joint with smooth interface and the composite joint with rough interface. The depths of the rough interface, shear keys and smooth surface were approximately 6 mm, 20 mm and less than 2 mm, respectively. Results demonstrated that all specimens failed in shear mode. The load-slip curves of the specimens could be divided into four stages, namely the elastic stage, the slipping stage, the ultimate stage and the failure stage. The shear stiffness of the composite joints was 6.02~6.76 times that of the grouting joints. The shear stiffness of three grouting joints was similar, and the difference was nomore than 10.9%. The shear resistance capacity of the composite joints was 1.35~1.85 times that of the grouting joints. And these of the grouting joints with rough interface and shear keys were 33.5% and 14.9% higher than that of the grouting joints with smooth surface. It was concluded that the rough interface and shear keys led to superior shear performance. Based on the test results and the data from the existing research, the analysis was conducted on the applicability of the existing calculation methods for shear resistance capacity of joints. It was found that most existing methods gave conservative results for the grouting joints with shear keys and the composite joints with rough interface, and part of them gave unsafe results for the grouting joints with rough interface and smooth interface. Finally, taking the interface structures into consideration, a calculation method for shear resistance capacity of precast concrete column joints was proposed.

参考文献/References:

[1]孙哲, 胡翔, 薛伟辰. 预制混凝土柱接缝的施工要点与受剪承载力计算[J]. 建筑施工, 2015(5)564-567.
SUN Zhe, HU Xiang, XUE Weichen. Key construction points of precast concrete column joints and calculation of shear capacity[J]. Building Construction. 2015(5)564-567.
[2]李爱群, 王维, 贾洪, 等. 预制钢筋混凝土剪力墙结构抗震性能研究进展(Ⅰ):接缝性能研究[J]. 防灾减灾工程学报, 2013(5):600-605.
LI Aiqun, WANG Wei, JIA Hong, et al. Progress of Investigation on seismic behavior of precast RC shear wall structures(I): Joint Property Study[J]. Journal of Disaster Prevention and Mitigation Engineering, 2013(5):600-605.
[3]赵作周, 周剑, 侯建群, 等.装配式混凝土剪力墙结构水平缝抗剪机理及承载力计算方法综述[J].建筑结构, 2015, 45(12):40-47,39.
ZHAO Zuozhou, ZHOU Jian, HOU Jianqun, et al. Review of studies on shear resisting mechanisms and calculating formulas of shear resisting capacity of horizontal joints in fabricated reinforced concrete shear wall structures, Building Structure, 2015, 45(12):40-47,39.
[4]薛伟辰, 胡翔, 孙哲.预制混凝土框架构件接头受力性能与设计方法研究[R].上海:同济大学,2012.
XUE Weichen, HU Xiang, SUN Zhe. Research on mechanical behaviors and design methods of precast concrete frame structure joints[R]. Shanghai: Tongji University, 2012.
[5]FOERSTER H R, RIZKALLA S H, HEUVEL J S. Behavior and design of shear connection for load bearing wall panel[J]. PCI Journal, 1989,34(1):102-119.
[6]Bass Robert A, Carrasquillo Ramon L, Jira James O. Shear transfer across new and existing concrete interfaces[J]. ACI Structural Journal, 1989,86(4):383-393.
[7]SOUDKI, K A, WEST J S, RIZKALLA S H., et al. Horizontal connections for precast concrete shear wall panels under cyclic shear loading[J]. PCI journal, 1996, 41(3), 64-80.
[8]万墨林, 曾兵. 大板结构接缝的强度和刚度[J], 建筑结构学报,1986,7(4):54-69.
WAN Molin, ZENG Bing. Research on strength and stiffness of fabricated concrete large panel joints[J]. Journal of Building Structures,1986,7(4):54-69.
[9]柳炳康, 宋国华. 装配式大板结构竖缝抗剪机理研究[J].郑州大学学报(工学版),2002,23(2):74-78.
LIU Bingkang, SONG Guohua. Study on shear-resistance mechanisms for vertical connections of precast reinforced concrete structures[J], Journal of Zhengzhou University(Engineering Science), 2002,23(2):74-78.
[10]王伟,苏小卒,赵勇. 钢筋混凝土界面剪力传递性能试验研究[J]. 建筑结构学报, 2013, 34(9):73-81.
WANG Wei, SU Xiaozu, ZHAO Yong, Experimental study on shear transfer behavior along RC interface, Journal of Building Structures, 2013, 34(9):73-81.
[11]MATTOCK A H, HAWKINS N M. Shear transfer in reinforced concrete-recent research[J]. PCI Journal 1972; 17(2): 55-75.
[12]BIRKELAND P W, BIRKELAND H W. Connections in precast concrete construction[J]. In Journal Proceedings. 1966, 63(3): 345-368.
[13]ACI 318-19. Building code requirements for structural concrete[S]. Farmington Hills, MI: American Concrete Institute, 2019.
[14]PCI design handbook(8th edition): precast and prestressed concrete[S]. L Chicago: IPrecast/Prestressed Concrete Institute(PCI),, 2021.
[15]EN 1992-1-1-2004/A1:2014, Eurocode 2: Design of concrete structures-Part 1-1: General rules and rules for buildings[S]. Brussels: European Committee for Standardization, 2014.
[16]Concrete Design Committe: for the Standards Councli(New Zealand). Concrete Structures Standard: Part 1-The Design of Concrete Structures NZS3101: 2006[S]. Wellington: Standards New Zealand, 2006.
[17]Building & Construction Authority(Singapore). Structural Precast Concrete Handbook[G].Singapore: Construction Industry Development Board of Singapore,2001.
[18]JSCE Guidelines for Concrete No.15. Standard specifications for concrete structures[S].Tokyo: Japan Society of Civil Engineers, 2007.
[19]中华人民共和国住房和城乡建设部.装配式混凝土结构技术规程:JGJ1-2014[S]. 北京: 中国建筑工业出版社, 2014.
MOHURD. Technical specification for precast concrete structures: JGJ1-2014[S].Beijing: China Architecture & Building Press, 2014.
[20]中华人民共和国住房和城乡建设部.混凝土结构试验方法标准: GB/T50152-2012[S]. 北京: 中国建筑工业出版社, 2012.
MOHURD.Standard for test method of concrete structures: GB/T50152-2012[S]. Beijing: China Architecture & Building Press, 2012.
[21]MILLARD S G, JOHNSON R P. Shear transfer across cracks in reinforced concrete due to aggregate interlock and to dowel action[J]. Magazine of concrete research, 1984, 36(126): 9-21.
[22]RANDl N. Investigations on transfer of forces between old and new concrete at different joint roughness[D]. University of Innsbruck, Innsbruck, Austria, 1997.
[23]RIZKALLA S H, SERRETTE R L, HEUVEL J S, et al. Multiple shear key connections for precast shear wall panels[J]. PCI Journal,1989,34(2):104-120.
[24]屈文俊, 毛雯婷, 郭志卓.既有混凝土柱-现浇梁界面受剪性能研究[J].建筑结构学报,2014,35(9):57-63.
QU Wenjun, MAO Wenting, GUO Zhizhuo. Shear capac ity of joints connecting post-cast concrete beams to existing structures[J]. Journal of Building Structures, 2014,35(9):57-63.

备注/Memo

备注/Memo:
收稿日期:2021-04-01修改稿日期:2021-04-20
基金项目:国家自然科学基金项目(51878478,52130806)
第一作者:刘博研(1995—),男,硕士生,从事预制混凝土结构研究.E-mail:1732525@tongji.edu.cn 通信作者:薛伟辰(1970—),男,教授,博士,“长江学者”特聘教授,从事现代预应力结构、预制混凝土结构研究.E-mail:xuewc@tongji.edu.cn
更新日期/Last Update: 2022-04-28